ABOUT ZHONGLIAN

FAQ

1: What Should I Do If The Jumper of The Edge Machine is Disconnected?

Adjust the tension of the thread, adjust the position of the crochet needle. If the thread is jumped when turning, check whether the turning parameters match the stitching of the machine head and the speed of the swing frame.

2: How to Solve The Oil Leakage of The Machine Head of The Sidewall Machine?

Tighten the oil cover of the edge machine head, try to use thicker oil.

3: How to Solve The Problem That The Noise of The Edge of The Edge Machine is Too Loud?

The machine head needs to add lubricating oil.

4: When The WB5B Turns The Corner, The Mattress is Not in Place

Increase the parameters of the rotating frame at the touch screen.

5: What Should I Do if The Machine Head Does Not Work?

Check whether the deceleration and turning photoelectricity is abnormal, whether the speed and parameter settings are correct, and whether the inverter alarms abnormally.

6: What is Our Main Business?

Auto-high speed quilting machine, Auto-mattress tape edge machine, Border 5 in 1 making line, Mattress panel flanging machine, Packaging machine, Mattress transfer conveyor and the other automatic intelligent assembly equipment.

7: What Should I Do if The Belt Does Not Move When Moving Forward and Backwardi

Check whether the inverter alarms abnormally and whether the machine head motor stops at the needle position.

8: What Should I Do if The Swing Frame Does Not Move Back After it is Rotated in Place?

Check whether the swing frame exceeds the limit when moving forward, that is, the front limit senses.

9: What Should I Do if The Mattress Drifts When The Swing Frame Rotates?

Check whether the pressure of the swing frame is too small, and increase the pressure of the press.

10: What Should I Do if The Table Cannot Be Raised and Lowered?

Check whether the lift switch, limit switch, contactor and motor are abnormal.

11: What Should I Do if The Nose Does Not Move?

Check whether the switch, controller and motor are abnormal.

12: What Should I Do if The Head Motor Does Not Work?

Check whether the belt is abnormal and whether the inverter is faulty.

13: How to Solve The Disconnection of The Overlocking Machine Jumper?

Adjust the crochet position.

14: What Should I Do if The Assembly Line Chain is Loose?

Adjust the sprocket to tighten。

15: What Should I Do if The Lock Head of The Assembly Line Chain Falls Off?

Reinstall, pay attention to the direction when installing。

16: What Should I Do if The Fixed Roller Glue is Loose?

Tighten the two M6 screws with a 5mm hex wrench.

17: What Should I Do if The Motor is Stuck or Overcurrent, and The Thermal Overload Protection is Activated?

Check the cause of the motor stuck or overcurrent, and then press the overload protection reset button.

18: What Should I Do if The Steering Platform of The Translation Lift Table Does Not Rise?

Check the solenoid valve, the air intake filter is waterproof.

19: What Should I Do if The Belts of The Upper and Lower Conversion Belt Lines Deviate?

Adjust on the installation shaft, tighten the M12 screws left and right.